Search results for query: *

There is a way to put the shifter on the floor if you want. I bought a kit from Hurst called the Indy Universal floor shift 3-Speed Shifter. This kit was fairly easy to install and has everything you need to convert from 3-on-the-tree to floor shift.

I ran into a problem when trying to install a bushing in my 273. What I did, since I could not find the bearing, was I put the bushing on a small sanding drum (3/4") and used a file to bring the outside diameter down to just a few thousandths of an inch larger than the hole in the crankshaft...

Just now reading this, and I have the same problem with my 1965 273. Summit has the conversion bushings now I think. I was googling pilot bushings and I saw a picture of one of those conversion bushings, and I clicked on it and it brought me to Summit. By the way, my clutch kit that came from...

OK, so I made a tool to remove the over center spring, and removed it. Then I went to the lumber yard and in the hardware section I found some nylon fender washers. I installed one at each of the connection points of my clutch linkage, and that seemed to solve the noise problem. Then I got my...

Thanks, I will try that. I am thinking that maybe I might order 2 new bushings for the shaft also.

I tried greasing all the clips and the ends of the over center spring, but it is still making that noise!

Hi, I was wondering if there was anything that can be done to stop the loud spring sound and squeaking that is coming from my clutch pedal every time I push the clutch in?

Here are some of the pictures that I could remember to take. I did have one small hiccup with this swap, the dual exhaust lines run right next to and just under the transmission. So when I went out to test drive it, I could hear an exhaust leak under the hood, where I undid the manifold pipe for...

Well I installed the A-833 in the Dart tonight, and let me tell you it was not easy without a lift. I put the car up on jack stands and used a small cheap transmission jack from harbor freight. But after a few hiccups it went in, like the throwout bearing getting knocked off of the clutch fork...

Thanks, that helps. I was wondering about the gas pedal bracket on the floor too, this fiberglass hump looks like it would possibly interfere with the connection of the pedal. If I position the hump so that the oval opening is centered above the shifter mechanism then it would be over the holes...

Hi guys, I am starting my A-903 3-speed to A833 4-speed switch and when I installed the 3-speed in the car (64 Dart GT) I had to make a floor hump out of sheet metal. Now I have a fiberglass floor hump, but I can't see where to put it. Does it butt up against the re-enforcing plate that has the...

If anybody is interested, Brewer Performance has just listed 63-65 fiberglass transmission humps back in stock. I just ordered one and I am waiting for it to be delivered.:cheers: