Search results for query: *

  1. Cuda Al

    Harness Tape/Wrap

    I get mine at the local NAPA Alan
  2. Cuda Al

    Dual ballast Ignition question.

    You should be able to just use the different coil with no changes. Alan
  3. Cuda Al

    Dual ballast Ignition question.

    You are going to get some long winded responses. The ignition and charging are not (directly) related. You can put a 4-pin module one a 5-pin system (dual ballast) You cannot put a 5-pin module on a 4-pin system (single ballast) Alan
  4. Cuda Al

    EMPTY TERMINAL BOTTOM OF 67 CUDA HEADLIGHT SWITCH

    If you are using the schematic downloaded from MyMopar it is NOT factory and is known to have errors. The best ones are those in the Factory Service Manual, the schematics for the Barracuda are in the Factory Service Manual Bulletin/Supplement. Alan
  5. Cuda Al

    EMPTY TERMINAL BOTTOM OF 67 CUDA HEADLIGHT SWITCH

    Ok, the block below the headlight switch is the fuse block? A yellow wire on the dash is either part of the dome light circuit or the starter wire (maybe others). Any ground wires (very very few) are typically black with a ring terminal and screwed to sheet metal. The fuse block has a couple...
  6. Cuda Al

    1968 340 Plug Wire Bracket

    131 views and no one has seen this on a 68 340? Makes me wonder if it was actually used from the factory. Alan
  7. Cuda Al

    1968 340 Plug Wire Bracket

    A friend of mine was asking about this bracket said to be for 68 340 engines, I can find no reference to it in the parts book or the assembly manual. Alan
  8. Cuda Al

    License Plate Bulb Connector Bracket

    This part? Nice Used https://www.ebay.com/itm/256358951967 NOS https://www.ebay.com/itm/364615401000 Reproduction https://www.ebay.com/itm/175065341742 Alan
  9. Cuda Al

    Positive coil wire

    That voltage regulator requires a different alternator and adding one wire from the alternator to the voltage regulator. (in a nut shell) There are electronic replacements for the earlier voltage regulators that do not require changes to the wiring. Alan
  10. Cuda Al

    Starter drain the battery dead???

    We still are not sure what wires were pulled from where. Alan
  11. Cuda Al

    Starter drain the battery dead???

    The only way the starter is going to pull power even at a trickle is if the relay lets it. Alan
  12. Cuda Al

    Starter drain the battery dead???

    I'd suspect the relay before the starter, even though you pulled the wire to the starter the power had nowhere to go so it went to zero. Pull all the wires off the relay and check the resistance through the contact. Alan
  13. Cuda Al

    Battery cable

    Looks like you are asking two different questions. The negative Battery Cable goes to the engine (as shown above) There is also a ground strap (wire) that goes from the rear of the right (passenger side) head to the body (firewall) Alan
  14. Cuda Al

    GPS tach ?

    I can see speed, that is done in most new cars. Even if you reverse engineer the RPM from the speed there is no way to know what gear it is in. Ok, maybe you preset a speed range for each gear through some learning mode. Not something I feel I would trust. Alan
  15. Cuda Al

    GPS tach ?

    If there is a GPS tach I'm going to get my tinfoil hat out. Alan
  16. Cuda Al

    Steering column wiring

    The brake light is a pre ignition circuit that came from the main harness. I don't know enough about the 70+ cars to know if this was part of the power going to the key, I doubt it as it was a fused circuit. Likewise with the turn signals, this was a post ignition (key on) circuit that was...
  17. Cuda Al

    Starter solenoid issues

    Check for parasitic drain. Alan
  18. Cuda Al

    alternator bracket issue

    I wasn't questioning why shiny chrome, I was stating why I thought you were replacing it. Alan
  19. Cuda Al

    alternator bracket issue

    Why? Shiny Chrome Alan
  20. Cuda Al

    Wiring Harness Options

    Yup, took me over a year to get some stuff for my Polara, previous time was a month or so. Alan
  21. Cuda Al

    Wiring Harness Options

    M&H will do stuff that isn't on there list as long as you have a good sample. Alan
  22. Cuda Al

    Dual point distributor ID question

    These are the same for both 66 & 67 2642242/IBS-4013A - Complete 2642461/IBS-4013AS - Partial (less cap/rotor) 2642358/IBS4013B - CAP -Complete 2642405/IBS-4013BS - CAP -Partial (less cap/rotor) 65 2444853/IBS-4013 - Complete 2444873/IBS-4013S - Partial (less cap/rotor) Alan
  23. Cuda Al

    68 Baracuda electrical questions

    Contact Bruce at [email protected] to have your wiper motor repaired/restored. Alan
  24. Cuda Al

    Low Beams dead, Hi Beam Fine?

    My money is on the relays or the hookup. Alan
  25. Cuda Al

    Head lights

    Idiots Guide to Electrical. Open the Factory Service Manual to the electrical diagrams, if you do not have one GET ONE, download from MyMopar.com Make copies of the diagrams so you can mark them up Highlight the circuit(s) in question I like to make a single line that I can add notes to as...
  26. Cuda Al

    69 Dart Trunk Light Location

    This is a 67 Barracuda, guessing it would be the same. Near the left hinge (inboard looking up) Alan
  27. Cuda Al

    M&H Electrical Fabricators

    Yes, I recently got a 67 Barracuda forward lamp/engine harness from Van's, better customer service than Year One. Alan
  28. Cuda Al

    M&H Electrical Fabricators

    Typically they do not deal direct, you must go through a dealer. At one time Year One was the only one but recent I have seen them being sold by others. They will deal direct on non catalog items like C-Body or some secondary harnesses. About 2013 I had them do the harnesses for a 1969 Dodge...
  29. Cuda Al

    Console wiring harness

    looks like it may have tach wiring. Alan
Back
Top