Search results for query: *

If the truck hoses are long you may be able to cut them down and have Napa crimp the correct ends back on them?

Good to know. I have probably been thinking the slant six used the same spacing as big and small block for 30 years.lol.

3.250 is a match.

The box is marked chrysler 383-413 60-66 in hand written ink? I checked fit to a big block housing and spacing is correct for that. I have no small blocks to check fit? I posted the picture as I always thought they were the same bolt spacing across the board. Slant to Hemi. Perhaps someone can...

Angled enough?

I got 5/8" tubes on my heatercore.

Says capable of 10,000 rpm. I won't be spinning it that fast.

I've seen where guys would use masking tape of the needed width to mark the cut line on the blade tips. Keeps the fan in balance if blades are all cut the same.

Cardboard in front of radiator. I know its tacky but it works.

Does your car have a aftermarket mechanical oil pressure gauge? Could be seeping at a fitting and trailing down a cable or wire.

I like this response best. Intelligent and sensible. You would need a different car to utilize some of these mentioned fixes for a problem that doesn't even really exist. Its a valiant and it doesn't have turbine vanes. Takes a lot of work and money to turn it into a Honda or Mitsubishi. Then...

Yes I have used dilluted lye to strip the anodizing off my grill surrounds. It definitely has a reaction to aluminum.

I did do quite a bit of searching on this before I posted my problem and you are very correct. I would say 99 % of the rust removers I read about are not to be used on aluminum. Even the naval jelly I used that did do a very good job where I could reach said right on the label not for...

After a ransak of all the little lady's cleaning stash I didn't turn up any of the products suggested above. Looks like a trip to the store is in order. I did find a product called super iron out stain remover and can report here for everyone's benefit to leave it under the sink. Didn't touch...

Here's a photo of Al's Toy in action just for fun.

I picked up a race hemi aluminum water pump housing and have been working on getting it cleaned up to go on my engine. I got this housing from Adam Adamic several years back if anyone was curious of its origin. His father Al ran a BO29 in ssba named "Al's Toy" out of Ohio when new. Anyway...

I would go 3/4 to 1" all around clearance. And half of the fan blade in the shroud. That strap is a real good idea with the rubber mounts.

Solid or rubber engine mounts?