Search results for query: *

I know on my 8 3/4 there are grease seals that press into the axle housing and then there are dust seals that go in front of the Axle bearing to keep dirt and water from getting into the bearing from the wheel side. My grease seals have a metal case with the rubber seal inside it, they do not...

thanks guys

Ok I have a 360 with a 833 tranny in a 72 Demon, I need a drive shaft but don't know what yoke will fit. I am being told 727 will fit is this true?????

I am interested if it's the 130 tooth 360 non magnum flywheel. Send me a pm when you find out.

Apparently I made a mistake with this post. I thought it was the trans/diff forum, didn't realize it said "tech forum" my mistake, just delete the post.

I need a flywheel for a 360 engine, must be external balanced and except a 10.5" clutch, don't want to buy new so if anyone has one to sell let me know ASAP.

I am using a 1976 360 engine in my 72 Demon so what flywheel do I need? I have the one the uses the 11" clutch but it won't clear my bell housing. I assume I need a flywheel that uses a 10 1/2" clutch but does it need to be balanced or not to use with a 360.

I am offered a 62 Dart Rearend for my 72 Demon but not sure that it will work, anyone know if this would work and if the bolt pattern would be the 4 or 4.5". I have a B Body rear I can put in but I'm told it is longer than the A-Body.

thanks

Maybe this is a no brainer question, but can I use a center section out of an 8.75 rear that was in a B Body and put it in an A body 8.75 housing?

So are either of those shifters for sale??

I will be using bucket seats and I do have a console, not sure if I want the console though.

Will any hurst 4 spd shifter work on a 72 Dodge Demon? If not is there a particular number I should be looking for.