Search results for query: *

On the top of the ps box there is a plate that has oil lines going into it. That plate is your adjustment. With car safely supported with front wheels off of the ground start the engine. If the wheel turns one way or the other on its own you need to adjust. The procedure is easy, loosen the...

They should be fine if it's an a body but you will need weight on them .

With radial tires 1/2 degree negative camber around 3 degrees positive caster . Toe-IN 1/16"to 1/8. Made sure to set your ride height before having it aligned.

Yes they will check the alignment for free but will charge for adjustments Is a scam to sell more alignments.

The tension comes from the LCA bushing. Loosen the LCA nut on the k frame a there should be no tension. It should be tighten at ride height only to avoid damage to the bushing

Every p/s pitman arm nut I've taken off has been 1 5/16" but there were all 1980 and up.

How much clearance is the on the other side? Is the K frame shifted to one side? The LCA bushing pin/bolt could be bent. K frame or frame rail maybe bent. Good alignment shop can tell you what if anything is bent by the alignment angles.

The steering arm (ball joint) to knuckle bolts are 3" long. The idler arm bolt has cotter pin but and no washers .If your has no hole for a cotter pin you could drill one or use red loctite.

Is it loose in the control arm or the steering knuckle There are two different sizes depending on the year Moog number are K704 small ball joint K772 large ball joint. There is nothing to shim. Also the upper ball joint screw into the upper control arm, many shops don't know this and try to...

Is the sway bar wider with the suspension at ride height or hanging?

TRW bought MOOG out about 10 year ago the quality went down some but still the best going. You can get moog part cheaper by getting trw ,but open the box to make sure it a moog part before buying it..It will be stamped next to the grease fitting.You have 50/50 chance that it will be a moog part.

If you have to replace them I would go with RMS control arms http://www.reillymotorsports.com/store/product.php?productid=16164&cat=265&page=1