Search results for query: *

I have an arthritic back and shoulder and now in my mid 50's I finally invested in a 4 post hoist now I have the room to put one. Picked it up yesterday and cant wait to install. I am so looking forward to not lying on the floor and hurting my back, shoulders and knees and make those jobs...

These look like a pretty trick flaring tool however I have seen them at Eastwood and all over Ebay at much less cost. They all look the same to me or does anybody know if the Aeroflow ones are any better than the cheaper ones.

I found this the other day at my local mens shed. It wont hold a hack saw blade as it doesnt tighten down on blade. Were these things meant to hold a wider blade or is there something missing from it. Its good quality made in England and I would like to use it.

I have had a gutfull of cheap chinese Rivet guns so I went out a bought a $70 Lobster branded one which I am still not happy with. Ok with small rivets but 5/32 rivet I had 3 pulls before snapping rivet with 2 hands. I did some research and found a Malco 2N1 which looks quite good and a lot of...

I have a cheaper $70 generic self darkening helmet but I see helmets as much as $500. Is there big differences in their performances the more you pay or are more or less paying for a brand name.

Anyone made a tool that aids in lifting third members/diff centres into housings. They are just to damn heavy to lift in with my arthritic hands, neck and shoulder. Have never seen a commercially made one which surprises me.

I have destroyed 2 billet aluminium crank turning sockets and i am sick of trying to repair them. Does anyone make steel ones that will last. Any recomendations?

Hi folks I am very new to spray painting. I have a good gun Anest iwata. When I spray I cant get a good finish of the gun. I wind the liquid needle out but never seem to get a good quantity of paint to give it that nice wet look. I am doing something wrong. Any tips you can give me...

I had been using a summit dial indicator and found it wasnt real accurate when filing back my rings on an electric ring filer. I was getting .001 to .003 discrepancies. I just bought a Mitutoyo 2414S Dial guage and have found it is so much better. The hands have a nice smooth operation and...

Bought this today and to my surprise wouldn't fit in my 4.030 bore. Has 4.030 stamped on it but measured it and it is 4.125. Do know if it is an oddball one or they have manufactured a whole heap like this.

Just purchased the Campbell Hausfeld VT627500RB 60Gallon 3.2RHP Compressor. Just had it wired and followed the startup procedure to a tee. Says open tank drain valve and open air flow valve and run at zero pressure for 30 minutes. Well thats all good but the compressor shut down at 25...