Howdy all. Looking for a seal kit to re-seal my 727. The front seal started leaking so i figured i might as well do all the seals. Can anybody recommend me a kit? Thanks
Howdy. Looking for a quality rebuild kit for my 42rh. I already have a transgo shift kit. Trans is going in a 76 dart swinger with a 300 horsepower 360. Thanks
I'm putting a O500 trans behind my 78 360. the trans is out of a 93 dakota. what flex plate do I need? It will have a lock up convertor also if that matters thanks
I need to set the pinion bearing preload. What do I torque the nut to initially to measure the drag with an inch pound wrench? I thought I read 240lbs somewhere. Is this right? Used bearings 742 case. Thanks
not an a body but drove a friends 57 chrysler 300c 392 hemi to a show last week. I noticed that when it shifted into drive too early. shifted fine, but too early. what could cause this? thanks
Putting an o500 Trans in my dart swinger. Any tips and advice on what mods I should make to the Trans when rebuilding it? It's out of a 1993 Dakota. It will be behind a 300 horse 360. Thanks
I have a 64 valiant two door sedan. i'm restoring it and want to make a cruiser/mild stree car. It will have a 400hp 360 with a cast iron case OD 833. i also have a 8 & 3/4 rear for it. what would be good gear set to run? thanks for any input
I've seen some articles on swapping a O518 trans for a 727. has anybody used the O500 instead of the O518? If the O500 is physically smaller, maybe it wouldn't require floor pan and crossmember mods. this would be for a small block A-body.