Search results for query: *

Anyone make 'em for our small blocks?

Can anyone point me in the right direction? I've read good things about smith bros, but I'm not aware of any other manufacturers. I didn't realize how much deflection stock pushrods allow until someone showed me a hands-on comparison (trying to bend them in a vice) between stock and 0.080"...

Hey guys, I have the opportunity to run a second hand solid flat tappet camshaft with correct lifters, numbered and packaged in order of prior fitment. Some say "don't take the risk!" others say "if it's in good condition, run it!" What are your thoughts and experiences?

Ok, so I have a nice mild little 318 in my valiant. it's dyno'd at about 350hp @ 5700RPM 10.2:1 comp Hydraulic cam 227/242 @ .050. 107lsa. about .480 lift Performer RPM. 650AVS Stock 915 J heads with ferrea 2.02/1.6 valves and a 3 angle job 1-3/4" headers I have a set of bare Edelbrock heads...

What do you guys think. does this pretty much sum it up?

Hey guys, What's the deal with converting to a solid roller? I've heard that bushing the lifter bores is necessary, I've also heard it's optional. What brand of lifter do you consider to be the best/worst/middle of the range? Does anyone have real world experience to share regarding swapping...

Hey all, as some of you know I have had some detonation issues with my 318 recently which saw the need to pull it down and have the bores honed and a new set of pistons. Specs this time are as follows 318 +.040 10.2:1 compression 915 J heads, ferrea 5000 valves 2.02/1.6 slight bowl blend. Scat...

Hey all, I have some bare Edelbrock heads on the way here for my little 318. I read this article. I'm sure you're all quite familiar with it http://www.carcraft.com/techarticles/ccrp_1110_pump_gas_small_block_mopar/ Those cylinder heads look like works of art and I was wondering what something...

For all of you who like to tinker with engine sims. I thought i might show this one off if you haven't heard of it. I'm sure it's probably against the rules for me to provide links to the cracked version of this program, So I'm afraid I can't do that. on a completely unrelated note, My inbox...

Hey guys, I'm looking for a good solid cam to replace my hydraulic Comp Thumpr. Specs are as follows 3200lb 67 Valiant. (estimated w/driver) 318+ .030 Forged pistons. 915 j heads 2.02" 1.6" slight bowl blend 10.25:1 comp 3000 stall 904, Transgo TFII 3.7 gears. 25" street tires. The cam I'm...

Noticing a lot of ticking and some smoke out the exhaust in my freshly built 318. have a couple hundred km on it now and thought I was in the clear. WRONG I Pull off the vacuum line to the rocker cover and notice HEAPS of blowby. Crap....rings? So I pull the plugs for a compression test and...

Need some advice on which VAC SEC carburetor to run on my stout little 318. specs are as follows 1967 Aussie VC valiant. (same as USA's 1966 valiant) 318 + 0.030" (323ci) 10.39:1 CR (KB399 pistons) 915 "J" Heads with minor bowl work 2.02/1.6 Valves Comp Hyd Thumpr cam (227/241 @ .050") Cast...