Search results for query: *

Good day everyone. I made a post a few weeks ago about valve sizes and valve springs. Welp the time has come that I'm ready to tackle the job. I'm planning to do the nylon rope trick and was wondering what's the consensus on length of rope to use? I don't have access to an air compressor.... ...

Good day to all. I have a 360 engine with stock X heads. My valve springs are getting weak and I'm planning to replace them. I have dual springs on it that matches the roller cam setup. I was wondering what is the valve guide size. It's been years since I've had the engine built and having...

Ok....I have a question....I understand about the need of zinc in older flat tappet cam engines and not needing it in a roller cam type setup...Now my question is lets say a 1998 Nissan ( I kno it ain Mopar don't shoot...lol) Altima 4 cyl with an overhead cam uses a cam an bucket style...

I was doing some looking at year one site. I see they have a mp 284/294 484 hydraulic roller cam for only 245. It comes with lifters, even though they may not work with a LA block. Not a bad deal for a roller......Just throw it out there in case someone looking for a cheaper priced roller cam....

Ok. I have a dilemma/debate:clock: going on with myself right now. Towards the end of the year I plan to put my Demon on a boat to bring it to Nassau Bahamas:cheers:. Now I was trying to decide would it be easier/cheaper to drive it all the way, half of the way then tow rest of way, or tow it...

I found these numbers on my cylinder head under the valve cover 2843670-24.....okay I checked the numbers and it says they came from a 318 BUT it has aawj on one runner also (are they j heads).....I KNOW I took them off a 1975 360 block but the numbers are saying 318 cylinder head but from what...

Has anyone used one of their cams? It's a hydraulic flat tappet for small block apps...The video of the guy's 340 sounds damn good with the 340/360 cam....Post says 8.5 comp 340 not to much more other than that...If you never seen it check they website Hughes Engines.....Again I was wonderin has...

Anyone know if the edelbrock performer rpm heads are any good. I read about the rhs head and they seem good but seen those and wonder which will be better...Engine will be a .30 over 360(that's the first choice) I was also thinkin a .40 over 318....cam between a comp and crane....nothin that...

I have a 72 Dodge Demon wit a 318 in it.....The engine is .30 over wit a decent cam..360 heads that have been worked...The engine was built by a guy that drag races out of Petersburg Va. Don't know much more than that....Although when I start it or when I drivin round people think it's a...

I have a Demon that has cracked the flexplate.....It just cracked tonight.....I've had it break before....I was wondering what kind of damage I may do if I were to drive it from Danville to Richmond Va? It's a 2.5 hour trip....If I could get a quick response before 2morrow so I could schedule a...