Search results for query: *

Im plannin to buy new 750 double pumper carb. I found these carbs and they look like Holley DP to me but they are cheaper prize. Does anyone have experience of these and are they as good as Holley double pumpers? Brawler BR-67213 750 CFM Brawler Street Carburetor Mechanical Secondary

I bought IMMS rhs heads to my 360 and after swap I didnt see any performance gain. My old heads were badly ported 596 heads with 2.02 inch valves. They had clearly too small pocket porting area compared to valve thats why I thought that they are badly ported. I tried 35 and 33 ignition advance...

I torqued my oil pump to my block and it wasnt fully seated to the cap/block what happen was pump snapped in half and broked the bearing cap. Great! Look at these pics and tell if I need to repair this part or is it necessary? And if yes how to do it? First I thought that I solder it back with...

I got Comp Cams cut to length pushrods. How do I put the cup end on it? Sure first I need to cut tube to correct length but what then? Do I need to drill the pushrod tube before inserting the cup part? How to insert it, do I just press it? Part number for these pushrods is K8805-16. Pushrod cups...

What is correct bolt size and tread type for rocker arm shaft bolts? I overtorqued them and now I need to replace them all. They stretched so badly I dont even know what tread type they are. I tried google but found no info.

I have complete my build. i have not start the engine yet. What you think about this combo, and what hp it should or could make? 360LA -75 0.030 overbored KB107 pistons 10.1 to 1 compression 596 number heads, 2.01 intake valve, cant remember exhaust valve dia. Ported Comp Extreme Energy 282...

I have Crane roller rocker arms. I assemby now my engine and i have forgot how rocker shaft have to install. it has one oil hole for every arm. Should this oil holes go to up or down? it can be assembled both ways. It think holes have to point down, but not sure..

I run in problem. I bought comp cams 282 mechanical flat tapped camshaft and comps recommend 986-16 springs to use whit this cam. whit this spring it should to install to 1.750" and get 132lbs seat pressure. Now i measure my heads and i get 1.650" install height. (whit my old locks and...

i have started rebuild 360 -75 engine. What is maximum crankshaft bearing clearance that is acceptable? I Have stock crankshaft and it is worn. I have allready new STD bearings so i think if i could use them. Engine is +300hp. Use is street cruising, no racing.