Search results for query: *

I was wondering if anyone ran this cam in their 318 or do I need to go with another cam choice... My Setup: '87 Roller 318, Edelbrock 750, Weiand Action+Plus Intake, 302 Casting Heads, HEI Distributor (Have A Unilite Also), Shorty Headers, A904 with High Stall & Low First Gear Set, 3.55 Gears...

It's about time for me to make a few changes to my engine and I'm leaning towards the camshaft. I have the Diplomat engine equipped with the "302 casting" heads and hydraulic roller camshaft. Its daily driven and hurt feelings too :D My goal is to increase performance without throwing my...

Does anyone have pics of their custom made throttle linkages, brackets, etc. for a small block? Thanks in advance!

Purchased a 318 from a 8? Diplomat (Hydraulic setup). I performed a quick rebuild and installed a Mallory Unilite distributor, 4-bbl carburetor & intake, and a double roller timing chain. To set the timing, do I bring the #1 cylinder up like other 318's or is there something I'm suppose to do...

Is it difficult to swap to the straight style after removing the 90 degree adapter? What is required to make this swap?

When installing the rear main seal (block side), does it fit all the way into the groove before installing crankshaft or will it rest on the two extended ends? Also, will those ends flatten easily as the rear main is torqued?

:banghead: I'm in a situation where I lucked up and purchased a hydraulic roller 318 with the 302 casting heads for a decent price. I purchased the Comp Cams camshaft and lifters for another engine. Would you leave the stock roller setup as is or replace it with the XE262H?

Went and picked up an engine Friday and started tearing it down yesterday. I left the short block standing up on the timing chain cover. It was slightly tilted due to the balancer and crankshaft bolt still attached. I went to take the flex-plate off and rotated the bottom end by accident...

This is my first attempt of block honing. I purchased the Lisle Engine Hone that has the three stones. I went through all cylinders at 30 seconds each cylinder (1 full stroke = 1 second)... End result: Should I go back over the cylinders with the same process or that's fine as long as it's...

It's about that time to assemble my first rebuild soon. I'm about to order Clevite Engine Assembly Lube along with Comp Cams Break-In Additive and was wondering is there anything special needed for rocker arms, push rods distributor gear, and springs. I know Comp Cams offer an assembly spray...

I've been doing some research on milling 318 heads on various sites which means different opinions and the whole nine. I took some notes and wanted to see what I recorded is correct. I'm thinking about using the heads (4027593/4027163) that came off my motor since I already have them. .020 (no...

I'm in the process of rebuilding my 318 which is a '77 model. While browsing for a set of lifters on eBay, I came across a few sets of factory roller lifters. The thought of adding them for a small gain wouldn't hurt anything, but the one question came to mind... Will it work? Thought about...