Search results for query: *

I replaced a couple of leaking block plugs on my '77 360. Used the 1 5/8", Doorman 555-030. It shows the open end dia to be 1.643 with the closed end diameter, 1.63. Heigh is 0.50 This plug dropped in with not a lot left to drive it in. I tapped it in with the rim being a bit more than flush...

Engine is a 1977 360. I bought the engine rebuilt and did not have an oil pump. I purchased a melling 72s pump. The mounting neck will not fully seat, which does not allow the pump outlet base to mate up flush with the bearing cap. There is a "step" (see attached pic) in the bushing hole that...

I have a rebuilt '77 360 that I purchased and came with what appears to be the wrong oil pan. There was not a gasket on the pan when I got it. I purchased a gasket for a '77 but it does not mate up with the pan. The rear of the pan does not have the ribs like the the gasket. From what I...

'69 318. I bought a new lifter to replace a suspect bad lifter and I need some help understanding this. When a lifter is working properly there should not be any give when pressing on it, correct? The one I pulled out could be depressed a bit. When I pulled the new one out of the box I...

First post and question. I am replacing the valve seals on my '69 318. I noticed the the rods are different diameters. One is .281 and the other is .313. The way they are in place right now there is no consistancy of intake or exhaust. Also one has a ball on each end the other does not. Does...