Search results for query: *

Sorry I can't say or even hint what I'm talking about until the prototype is made and patent it. But, I will let you know that it will be a desired item on practically any engine combo from completely stock to a full blown 8 sec drag car small block to big block. And if you reply to this with...

I am wanting to build a flow bench. Has anyone built one? I'm looking into this kit alsohttp://www.flowperformance.com/system.html

Kinda a general question on the HP and TQ gain from 10.1 comp to 11.1 comp. How much will it really gain? Based on Iron headed sb.

OK here is the setup 67 notch weight 3300lbs Chassis STK ft shocks with /6 tors. STK rear shocks, /6 leafs with extra leafs added. NO snubber or traction bars. B body 8 3/4 with 3.91 sure grip 360 .030 10/10 STK crank Eagle sir rods KB 107 pistons .005 positive deck. Out of hole 587...

ok spec on setup. 360 .030 kb pistons 10.2to1 comp. run 93/110 oct 50/50 mix J heads ported with 2.02/1.60 hughes engines cam HTL4852s solid cam. 248 252 @ .050 .563/.572 106 lsa. air gap intake,Hooker super comp headers, carter race mec. fuel pump, holley street avenger 770 carb , pertonics...

ok spec on setup. 360 .030 kb pistons 10.2to1 comp. run 93/110 oct 50/50 mix J heads ported with 2.02/1.60 hughes engines cam HTL4852s solid cam. 248 252 @ .050 .563/.572 106 lsa. air gap intake,Hooker super comp headers, carter race mec. fuel pump, holley street avenger 770 carb , pertonics...

I had a set of comp 821-16 solid lifters laying in the shop that I was going to use. These lifters do not have a oil groove cut in them. Will these work? Or will it block off the oil in the gallery ? These look very heavy and I might just get some with the direct lube, but just curious thanks.

What's the safe maximum amount you can cut the spring pads on 596 heads? I need to cut .050 to get my installed heights right with a valve length of 5.00. Will this be ok? Still would like to know max about cut for future knowledge . Thanks

I have a set of 596's fully ported with 2.02 1.60's ok original plan was running a fairly healthy solid cam,but right now I need to run a small hyd lunati cam 230/.480 im using a set of bb springs with installed height of 1.8 and diameter of 1.5. My solid lift dual springs were set at that...