Search results for query: *

I found a video of someone using one of these to drill out and install bronze valve guides on the youtube. It appears to have been long discontinued and very hard to find. Anyone use or have one of these things?

i’m trying to figure out where to buy the correct piston pin c clip retainers for my stock style late 80’s Sealed power 2369p pistons with floating pin. One of my clips is bent so i’d like at least one but would prefer to replace all of them. I’ve searched online and this forum and the ones i’ve...

So i just measured my crankshaft main and rod journals to check for wear and taper .I’m doing a light rebuild with new bearings and rings and seals. I had this crank machined decades ago when i was in high school by a machine shop that is no longer in business. the rods are .030 under and the...

I’m trying to identify these aftermarket 340 pistons from a 30 year old build. the casting number is 1029p . I had the short block rebuilt when i was in high school. I don’t remember specs . I remember the guy taking me into lowering compression ratio to run pump gas. Probably because i was a...

I found resale shop online that specializes in nos car parts that has this 40 year old sealed power replacement 340 cam . I looked up part numbers and verified that it’s the correct cam. the only thing i’m concerned about is condition. I looks like there might be a small amount of rust on the...

Hear is a question i haven’t seen asked. I’m putting back together my mostly stock 340 engine out of my 69 swinger 4 speed . back in the 90s it had the mopar 292/508 cam with the recommended mopar red valve springs installed. i cannot recall the part number. I am planning on putting the stock 69...

I'm thinking about picking up a factory intake for my 69 340 swinger. My fender tag is Mia so I don't know the build date of the car . The cast date on the block appears to be around june of 69 but I could be reading that incorrectly lol. Can anyone help ? Thanks.

Anyone know of a decent machine shop in the Chicago area to get my 340 X heads rebuilt? They will be needing valve guides repaired or replaced and a valve job. Not planning on having any porting done. Thanks Dave