Search results for query: *

Hi guys. I ran the Dart 600 miles round trip from Connecticut to Carlisle and back and it ran like a clock. About 75 miles from home I stopped at Sonoco for gas and bought the 91 octane fuel. Once back on the highway I noticed the car pinging slightly going up hill at cruise speed. It didn't...

Hi guys. Taking the Dart to Carlisle in a couple weeks so I'm lining my ducks up. My car was converted to MP electronic ignition last fall. I need a 4 wire ballast resistor to keep in the glove box in case I need to replace it on the road. What year/type car should I order it for, and where...

OK guys, Most of you have been following my problems with my 340 stumbling and bucking. I finally threw in the towel and pulled the timing chain cover off to see if I installed the chain wrong. What I found was the CAM timing mark at 12 O clock, and the CRANK timing mark also at 12 O clock. I...

Hi guys, Still chasing this stumble here. Is this open center gasket OK to use with the stock manifold? Should it have the 4 hole style instead? Would it make a difference? Thanks, George

I bought a remanufactured distributor, a dial back timing light, a tach & dwell meter and a set of advance springs for the car. Now all I need are real world specs on what to set the advance and initial to. Here is the car: Stone stock 1969 Dart 340 with a stock 727 trans and 323 rear gears...

I thought my fuel pump was bad because the car died while running, and when I checked the carb squirters, there wasn't any gas coming out. Tonight I removed the fuel pump, and tested it with mineral spirits by hand. Seems to work perfectly. When I had the rubber fuel line disconnected from the...

The stock AVS carb on my 340 is flooding out. I had it rebuilt by a friend who is a retired race engine builder, and former NASCAS crew chief. I trust his work, but..... Anyway, the car starts fine and runs smooth for a few seconds. Then, it starts to stumble like it has a HUGE cam installed. I...

No, not me ya wiseguys! :D Can anyone tell me if a dipstick from a 72 Mopar 318 engine is the same part for a 69 340 engine? Will the readings/markings be the same? Not the tube, the stick itself. Thanks, George

Where can I get info on the jetting etc for a Carter AVS for my 69 340 automatic? Thanks in advance for any help guys. George