Search results for query: *

Hi, need some help. recent rebuild 340 mild cam, 1406 carb. mopar elec. distributor, timing set at 16. question is when i block the vacuum line for vacuum advance it runs great but when i unblock vacuum line to vacuum advance it has a hesitation when i raise the rpm. thanks for your help.

hi guys need some advise. elec. ignition, timing set at 18, ld340 intake, 1406 carb, mild cam. runs good at idle but when i put it in drive has a stumble or misfire almost wanting to shut down. car runs good at cruising and at highway speed. where should i start looking. any input would be...

need help on this timimg issue. timing set on 8 before but it jumps hi and low like 3 numbers at idel. its a 340 with ld340 intake, 1406 carb, 360 heads, mild cam, just built motor. where do i start looking. thanks

:dontknow: need some help i had a 318 in my 69 dart which was 72 date code on block. now i just built 69 340. my question is the three roll crank pulley does not fit, one bolt hole does not match. now what is the correct pulley what should i look for, the car has power steering, timing mark is...

Hi everyone doing my first rebuild on my 340, my be a dum question but sence this is my first rebuild just want to make sure. does the installation if the oil pump take any gasket or o-ring. Thanks for info.

Hey GUYS My question is whats the install on these looks like the notches on these rockers are the same. do the notches go in the front or rear. any info. thanks

hey guys, this may be a dum question. i am replacing my sb valve covers with the mopar performences valve covers and the air cleaner black wrinkel so what do i do with the pcv.

hey guys, just got my 340 from machine shop they did the short block now i have to assemble the rest. This is my question what type of thread sealant should i use on the bolts there are so many sealants out there. any info would really help.

Hi guys I have a 340 that is being rebuild, the build is petty much stock build the onlything is i am using oem mopar adjustable rockers and running a hyd cam. need to know what size cup push rods to use and where to get them or part #s thanks for your help.

hi guys will early 360 heads work on a 340 block? the heads are stamped 360 on the inside. thanks for your help.

hello everybody, i have a sunpro water temp gauge its mechanical where can these be installed and i also want the dash gauge functional. :help:

hey everbody i have adj. mopar rockers that are going on a 340 j heads. what type of push rods should i be using. i am going mild on my engine build. thanks for your help.

Need help. Does anybody know where this bolt goes? Its 7/16 head, its a hole in the middle of the bolt. Thanks.