Search results for query: *

my question: is there suppose to be an inner fender well clamp that holds heater hose's in place or do the just lay there and if so does anyone know who sells them. I do have the two aluminum straps that go on them already! Also if a clamp is used I do not see any hole to use on top of inner fender?

I have a leak on one of my water pump bolts that hold the alternator bracket on! I read the service manual and it does not say to use RTV on bolts upon assembly. my question is should I use RTV on bolts or do I have another problem that I am not aware of that is causing this issue?

I have read a couple of post and I am thinking that I am going to have to modify my core support to go from 6 cylinder to V8 Radiator? if so, what are the steps? or did I just misunderstand what the post said?

this is the radiator and shroud I got with my Duster, but, it seems that this is not the correct radiator and shroud for my duster! Does anyone know what vehicle they are for and what year?

does anyone have the bracket that goes over the heater core tubes on the fire wall, "for sale?" I can not find mine or maybe I did not even get it when I bought the car.

I sure wish I had not gotten ahead of my self on this, because I think that putting it in would have been a lot lot easyer with front windshield and dash removed. My question is do I hook up cables first before trying to slide heater box into place or put box in first then put cables on?

can anyone tell me what these metal clips are for on my heater control cable's?

I bought this heater vent hose kit for my 1970 duster, which came with no instructions! It seems to me, that after I put the two rubber spacers on the vent tube necks, there appears to be, not enough room now, to install the hose's and clamp's. I was wondering if any one else has ran in to this...

can anyone tell me if there is a gasket that goes around the big hole where support rod is at? if I do not have the gasket can I just use rope gasket?