Search results for query: *

I've been putting off checking NSS. This week I Checked the switch and deemed it to be bad. The head scratcher, NSS unplugged and switch in tranny. I tried to start the car , It did. That shouldn't happen right? What am I missing.

Bought a set of after market gauges , all electrical , temp oil , volt. Directions say to wire power to ign start . My question is , can I put all three guages on one feed wire or would it be best to spread the load out . No indication in directions on what amps they pull .

I'm having sending unit problems. New sending unit. I have done all the fuel gauge tests and the guage works. I have voltage to sending unit. I'm grounded to the same place as my fuel pump and it works fine. I've put my multimeter on everything and its all checking out. I even pulled the sending...

Just finished wiring my 68 Dart. Pluged in the insruments to check them. Everything was ok except my right blinker wouldn't blink. Bulbs good, I have power to plug in. When I pushed on the plug in it would blink. I pulled the plug and noticed that the pin was loose. What is the best way to...

Desided to rewire my Dart. Old wiring was really hacked. I already had a after market harness (GM color code). No more connector through the fire wall. Sence I'm not using a Mopar Harness, how do the three wires from the NSS hook up ? Is it still outside wires to back up and middle to ground ...

For those of you that responded to my question about after market wiring and ballast ,thank you. Thanks for the diagram Joe. for some reason i couldn't respond on the thread. Zigs

Rewiring my Dart with an Its a Snap wiring harness. Everything was going ok until i got to the coil. Mopar way went through the ballast resistor, new way is GM colors going through fuse block. My question .Do I need the resistor ? I know it can't take a constant 12v so do I need to wire to the...

When I got my Dart, the under dash wiring was pretty much a mess. I've been slowly getting it straightened up but can't find where the fuse block mounts. My manuals don't show anything and I can't find anything on line. Is there a mounting bracket I'm missing and if so what does it mount to...

Pulled my instrument cluster, Now i have no ignition power. I have one red constant hot wire that was bolted to the amp gage. The ignition switch isn't fed by the instrument cluster is it, that would seem backwards. The red, hot wire mentioned is the only wire I removed besides the amp ground...

Ok tipical column to floor shift console swap 68 Dart. The shifter has the nuetral switch on it and i have the three prong NSS. I know that the middle prong goes to the starter relay and the other two are back up lights. I have gotten myself confused, i have read a dozen peoples explanation for...