Search results for query: *

So I have a 70 dart with 360 magnum it runs fantastic with an 8 pin HEI. When I replaced my distributor with a new factory style I retimed the car and noticed when I revved the engine up to 3-3500 rpm it was advancing another 10 degrees. This is strange since I have a locked out distributor with...

First off I had a bad ignition switch and fried the hei (don't ask lol). I replaced the module,and he car is running great. I'm currently getting ready to add a procharger so I have an FBO limiter plate that I'm using to lockout timing. Well with the distributor locked and vacuum advance plugged...

I wired everything today using the attached schematic, and when I go from start to run the engine dies. I'm using the ford starter solenoid instead of the continuous duty relay. Should I have not grounded the ford relay? I mounted it in the engine bay. What gives? Any help is greatly appreciated

Got 2 different regulators from advance auto and they kept over charging at 15.6v. I found and old wells regulator that says made in USA in the bottom of my spare parts drawer, sanded the edges for good ground threw it in and now car charges at a steady 14.3v. The kicker is advance wont return...

I have my coil and 8 pin module mounted to the right of the master cylinder. I bought the kit from classic HEI about 3 years ago. Do you think its to hot of a spot because of engine and header heat? I ask because it burnt up yesterday and I had to get a tow home. I went to advance auto bought a...

I have the gm Hei setup for ignition. Is it possible to run a 4 pole cutoff switch and just split the blue wire that runs to the alternator and run each side back to the cutoff switch? Then run the battery cable from the original starter relay to the cutoff switch, then to the battery? My...

for some reason they stay lit when i turn the parking lamps on. they do flash when i put either signal on. on the flip side the front parking lamps don't light up at all when you turn the lights on. could this be a bad light switch or is it a grounding issue. tom

where does this plug into? The wire runs all the way down my column and just hangs there. I dont see anything around to plug it into. Pics would be great Thanks Tom

Im currently putting my 70 swinger back together. it had points and a /6 in it. It now sports a magnum v8 and i do have a electronic distributor. what should i go with. I see some people going with electronic, or Hei, etc. I have an orange box with a engine harness that is in my parts bin...