Search results for query: *

  1. swedefish

    Mopar electronic ignition

    Helping a friend with his Satelitte. It's a 440 auto. He has a electronic ignition on the motor. It doesn't ignite when cranking the engine. I've helped him with replacing the electric harnesses both under dash and in the engine bay this winter. When attaching the timing light to the wire from...
  2. swedefish

    non A-body question, PT -03 trouble

    Been struggling with an issue on our PT Cruiser. It got a bad missfire from time to time when warm. Have turned the ignition key on and off three times to get any fault code but says "done". Today when going to the store I put the gaspedal to the floor but it stopped revving at 4k rpm (even...
  3. swedefish

    RB 383 -59 engine

    Got a question about the 1959 RB 383 engine. Could any RB distributor be used with this engine? Many thanks in advance /Lenny
  4. swedefish

    vacuum advance

    Trying to figure out the ignition vacuum advance. When I look at the shop manual for a -67 383 engine with 4 bbl carb, the vacuum advance should be set at 7.5 degrees at 12 " of vacuum. At what numbers do you guys set your vacuum timing advance or do you just tinker with it until best...
  5. swedefish

    Fine tuning

    First some figures about my build. 383 cid + .040 Square decked , pistons .022 down in the hole, steel shim gasket 915 heads with bigger valves KB dished pistons According to my calculation this would give a 10.2:1 in static CR. MP purple cam 284/484 Eddie RPM intake Eddie 750 carb...
  6. swedefish

    windshield washer motor

    I`m trying to get my electrical washer motor to work on my Barracuda -67. But it only runs when I jump a wire from the motor housing to negative ground on the car, and then push the washer button on the dash. Does any of you guys know how the motor nomally gets its negative ground? I did...
Back
Top