Search results for query: *

I'm looking for the part number for the problem solver ball joints for a 73 dart. I searched on summit and cant seem to find it. Thanks for your help.

I also have this posted in the racing group but want as much info as I can get. Took the race car out for breakfast today. After leaving I was pulling out into traffic got straight and nailed the throttle. All was well, got home and notice the driver side of the car is sitting 3 or 4 inches...

So I got my 73 and up disk conversion on my 71 dart and the turning radius is garbage... Is this a normal thing? The car turned great before the swap. Any ideas why it sucks so bad now?

Anyone use these? QA1 Ultimate Ball Joints 1210-200S Ate they the same as the problem solver joints? Anyone got the moog partnumber?

Will the box out of our 64 Plymouth fit my 71 dart? The 64 is a non power box and that front end is going away so I'm wondering if it can replace the PS box in the 71 dart? Also is the 64 BB K member swappable into my 71 dart? I have a 318 K Member and wonder if the 426 BB K is better for my...

I didn't like the look of the column, it just didn't fit the style of my car any more. I cut it apart, pulled the shaft out and bought a shaft mount from Joes. I cut 3 inches off the factory shaft (to get behing the splines and roll pin hole) and added a 12 inch section for 8 more inches of...

Hi folks, did the 71 darts have a collapsible steering column and if so what section is it? Is it under the dash or in the engine bay? I want to get rid of.my column but I'd like to use the collapsible section (if its in the engine bay) so I don't get stabbed in the chest by D shaft in an...

Hi folks. I was wondering if I can remove my PS pump and cap off the box? this pump has not had or held fluid in manny years so the box is prolly already hurting. Just.looking to remove some junk under the hood. Thanks again.

Hi guys, I need some help. I just finished rebuilding the passanger side front end of my 71 318 Dart and I cant figure out where I went wrong? All new ball joints, bushings and bearings. I set the car on the ground and tightened it up then went to adjust ride height using the A B subtraction...