Search results for query: *

just a simple question about spring relocation kits. has anybody had any problems cornering, like normal cornering in the neighborhood or curves on the highway? it just seems a little weaker than factor hangers.

i have been look most of the day and I cant find OEM sway bar bushings anywhere. does anybody know who sells OEM (rubber) sway bar bushings for a 69 barracuda.

I installed my new t bars in the 66 dart this week and was adjusting the T bar bolts up to fit in the dimple in adjust arm, however I did notice one bolt sits deeper in the LCA than the other side, what's the fix?

ok so I am almost done with the spring relocation in the 65 barracuda gift to my brother. at the beginning with the 7.25 still in the car I measure its pinion angle with no weight, it had a 5.5 negative angle, it has SS spring in it. would be correct to set the 8.75 narrow rear end in car and...

There are alot of numbers out there and I need correct measurements. Tonight I will be shorting an 8.75 housing for a 65 barracuda, flang to flange whats the width, also I would like to reuse my axles from my 69 barracuda. temporarily of course.

Quick question.... I wanna order SS spring for my 69 barracuda 4 spd car what's the preferred weight of spring classification 2800, 3200 etc. Thanks for the tip.

my issue.... i have a 69 barracuda 340 4spd car. somebody put 73 disc on the front, i still have factor 69 LCA with sway bar brackets, i cannot completely turn left or right due to the forward facing lower ball joint attaching bolt to spindle hit the sway bar bracket regardless the height of...

quick question. did a 69 barracuda come with big upper ball joints?

ok so I put in the new torsion bars in the 69 barracuda. I need to move car. the shop manual says not to tighten up and front suspension parts until there is weight on the car and frontend height is adjusted, what's considered weight, I have a block and 4 speed in it right now to gets parts...

I have a 69 340 4 speed barracuda, disc brake car as far as I can tell. I was about to remove LCA but noticed the steering radius was not moving lock to lock, I have 1/4 inch gap between steering bump stops. this is due to the LCA bolt hitting the sway bar bracket on the LCA. so I thinking...