Search results for query: *

What all can I do with the front end while the engine is out? It certainly would be easier, as far as access, but It dawned on me that maybe the engine has to be installed, in order to establish ride height, to be able to do front end alignment, bushings, replace torsion bars, etc(?)

I purchased this rear sway bar a while back, turns out it is a discontinued model, but it was from a private party that had it for years and never got around to installing it. I believe it is a model 6905. Below is a picture of what I have a question about. The instructions say to install it so...

I have this set mocked up here, and in the picture below I actually have the right (passenger side) bar held up in place on the left side. So by swapping sides, putting them on opposite of the instructions, the new frame connector lines up well with the front frame section. (When installed...

I have only held them up in place to check fitment, etc, so far looks to me like the emergency brake cable is routed thru the frame directly where the atatchment plate goes. Its a little annoying that the instructions make no mention of the cable routing issue. Aside from the cable being in...

I'm interested in making some upgrades to the suspension under my car. The car is a 70 Dart w/ factory 318, 904 tranny, power steering, drum brakes. I'm going to do this upgrade on somewhat of a limited budget, so unfortunately for me, that limits my options quite a bit. But here is what I...