Search results for query: *

  1. stroker402

    afb 4131s surge at wide open throttle

    I have a carter afb 4131s (575-600 cfms) specs show , that I have gone thru and rebuilt . I have a full throttle surge that comes on around 5000 rpm when the secondaries are opening up. (just when you are getting into the secondaries) . everything is fine on the primary side. no issues...
  2. stroker402

    afb 4131s surge at wide open throttle

    I have a carter afb 4131s (575-600 cfms) specs show , that I have gone thru and rebuilt . I have a full throttle surge that comes on around 5000 rpm when the secondaries are opening up. (just when you are getting into the secondaries) . everything is fine on the primary side. no issues...
  3. stroker402

    carter afb dumping fuel out vent tubes .

    have a 273 commando engine with a afb 38523 that is shooting fuel out all the vent tubes . this just started today carb have ran real nice other wise. I took the top of carb off and cleaned and blew out the needle and seats , check the floats and levels , all looked fine . I didn't do...
  4. stroker402

    afb 4294s internal specs ? 67 commando

    I purchased a afb 4294s carb that was rebuilt by previous owners. 67 commando carb . Does anyone out there have the oem jet and step rods numbers . I opened this carb up before I installed it on the car to do a quick visual of everything inside the carb, It all looked to be there and...
  5. stroker402

    mopar won't stay running with carter 625 .

    :hello1:just installed a Good used carter avs 625 cfm. problem is......... it will not stay idleing .. have to hold the throttle on to 2000 rpms in order for it to run .. and it runs real bad like it is dumping gas down the carb. But it is not dumping ! Could this be a vacumn leak ...
  6. stroker402

    how large of a carb can perform well on stock 273 commando ?

    Just finished installing a ld4b on my stock spec 273 dartcharger .. also intalled a holley 650 dp with stock specs on top of that .. took it for a spin and it seemed like it was way too much carb . What are guys running out there?
  7. stroker402

    "The Right Stuff" sealer on intake manifold?

    switching intake manifold SB .. would the sealer called the "The Right Stuff" Be a good choice , if so........ in color black or Grey ? what is the difference in the two. I do have a gasket set also . Heard that sealer is really good . Thanks for any info !
Back
Top