Search results for query: *

My gas tank has 4 breather tubes on the side? What determined these? If I get a new tank can I replace it with a tank with no tubes?

Just replaced the fuel sending unit gasket hoping the leak would stop, it didn't . The outer ring is leaking. Is there a way to fix this or do I have to get a new one?:banghead:

Car's up on jacks, drained 7 gal of fuel, loosened the ring and it dripped for an hour. Where does the gasket go? Does the sending unit have to come out? Thanks

This is what you need. And yes the 71 spoiler is a one year only.

Just replaced the fuel filler tube gaskets and seal on the Demon. The next day I started the car, stock 340 with Holley single feed 650 Spreadbore, stock fuel pump, backed out of garage and then back in, only to find three pools of fuel on the drive, about 5" dia. I discovered the fuel line...

If you have a true "survivor" Demon I need to know if the fuel filler inlet tube was slid thru the quarter panel and then bolted on or is it attached by the three screws from the back side? It makes a difference when putting on the original style gas cap. Thanks a ton.

I want to remove this and re-install it the proper way. Looks like u just remove the 3 screws under the gas cap, remove the rubber seal in the trunk and will it slide out without dumping fuel from the tank? Any tips are appreciated. pm me please.

Gotta Hollery 650 Spreadbore 6210, got the choke working but where is the fast idle adjust screw to keep it running when I start it?

Is it possible to remove the filler tube without dropping the tank? I need to mount it thru the fender so the gas cap fits correctly. Anyone know the steps involved? Thanks

Which is better for street cruising? Mild 340, 4 spd, electronic ign, stock intake and exhaust. Thanks

Does Barry Grant make a spreadbore?

I have a newly resto TQ 800cfm and to adjust the secondary air door do you first have to unlock the larger screw to adjust the inner smaller screw to tighten the door? The inner screw moves without unlocking the outer screw.

I need the choke arm that goes up to the TQ carb. Any condition. [email protected]

It appears to be getting soaked with fuel from the inside. Just got the carb back from a beautiful restore.

The spacer that is about 1/2" thick?