Search results for query: *

I am looking for a magnetic drain plug for my oil pan and want to get it before my next oil change. I have a '73 440 with the 699 pan, is the thread on the drain plug 1/2-20 or something different. I am having a hard time remembering. Thanks

I ordered two Autometer gauges about a month ago. http://www.autometer.com/cat_gaugedetail.aspx?ref=search&gid=2792 http://www.autometer.com/cat_gaugedetail.aspx?ref=search&gid=2804 My original plan was to make up a panel to mount them under my dash. Shortly After I ended up...

I am working out all the fittings I need to install a new Transmission cooler in my car. I have a 440/727 in a '74 A-body. I am going to mount the transmission cooler in front of the radiator, in the lower drivers side corner. My Plan is to use this transmission cooler: B&M 70274...

I swapped a 440 in to my '74 Duster a few weeks back, I have had a few things come up between now and then but I am addressing the clearance issue with the driveside valve cover. I am looking in to ditching my power disc brake setup in favor of manual discs. I am going to offset the manual...

Topping off my 440 I have a set of stock vavle covers. I don't trust them, I cant get the inside of that baffle clean enough, atleast where I would like it to be. I would love to change them out for somthing else. What other options are out there that will fit in a Big block A-Body? My...

Topping off my 440 I have a set of stock vavle covers. I don't trust them, I cant get the inside of that baffle clean enough, atleast where I would like it to be. I would love to change them out for somthing else. What other options are out there that will fit in a Big block A-Body? My...

Alright, I am not sure if this is in the correct area or not, so if the moderators see fit please move it to the correct area. I am finishing up re-building my 440, I am going to go over the transmission and start to put it in the car. Obviously I have a lot of things to get set-up before i...

I am working on rebuilding a 440, pretty much stock nothing special really. I am going to be using the 699 pan. I was really surpised when I pulled the pan off the engine and didn't find any baffles in it. Now I am trying to do some research on baffles and see what works and what doesn't. If...

Mods, not sure where this should go so please move to you're until you see fit. I am about ready to start working putting my engine and trans in so... since I switched to a floor shift I will need a new shifter. I like the B&M shifters but want to put a console in it. I have seen some pics...

I am rebuilding a 440 from a 73 Chrysler Imperial, I am doing it on a very tight budget. I have gotten to the point where I am ready to put the pistons and rods back in, I was orginally going to reuse the stock pistons but now I am having second thoughts. I have had the block rehoned and checked...