Search results for query: *

Subject pretty much says it all. Looking at the inner tubs there's a notch so the hinges don't contact the tub when trunk lid is closed. Knowing the top of the hinges slide in to and bolt to the trunk lid if you move the hinge braces to the center then the hinges won't line back up with the...

So this gal at my work just bought a new 4 door Jeep Wrangler. Nice! She went back to the dealer to get the step bars installed and I was checking them out this morning. Picture is what I saw, removed and comment in title of this post reflects. Sad.

7/8" X 3" casting boss on r/side "only" has the following stamped into it: PP833 4644, no partial vin or other markings. Nothing to the right of this number either? Posted this on the 4 speed forum over the weekend and nothing yet. Figured I'd try here as I cruise this forum more than other...

I'm super bummed. My project is a super slow process and last January (2010) I got started clearing the car off, then picked up a Dodge/Plymouth Paddock catalog and folded over many pages of things needed. Well just this weekend I came across the catalog again, after thumbing through it and...

I was at a local car show this week and saw this handle. The last time I saw one of these was about 20+ years ago in a GTO Judge. I've been looking ever since and haven't seen one anywhere; in a speed shop, other car, or in any magazine. Any idea what it is, who made it, where I can find...

Take a look at the pictures - what do you think? Any good? It has SBB axles so I'll be needing the BBP. I figure I'll do bearings and such when I'm ready for it to go in, whenever that may be . . . definitely a long way off. Question on the marks on the section in the 4th picture. It appears...

I came about an ad stating: I have a Dana 60 for an A-body that was built to be a direct replacement drum to drum and spring pad location. It has a 3.54 ring & pinion,trac lock posi unit,New Yukon 30 spline axles with green bearings installed,4.5" bolt pattern. It has backing plates for 10"...

My Duster came with full floor mats = no carpeting, two pieces just like carpet would be, only black rubber. Of course they're shot :angry7: I haven't seen them anywhere :crybaby: and would prefer not to have to use carpet. Anyone hear of repops or any other method of acquiring them...

At this point its a "rust-o-rot" :cry: low milage and no matching numbers on anything. So its my artistic/hot rod pallet - so to speak. :cheers: Just ordered the full floor from AMD http://www.autometaldirect.com/images/uploads/3636A_web.jpg $429 + 125 shipping. 8) I ain't touchin'...

A big THANKS goes out to 340sFastback for giving me the tip that AMD may start reproducing A-Body floors. I contacted AMD @ [email protected] inquiring if there were plans to pop floors. The short story of the replies between they and I are: 1 yes they are, 2 sometime in mid 09...