Search results for query: *

Valve body and park rod, came off a 71 904 trans, was swapped for a manual valve body, $25 shipped to lower 48 states from SE MN.

moroso part number 64930 1 inch 4 hole carb spacer. $20 shipped to lower 48 states from SE MN.

4 blade fan with spacer and original bolts, $25 shipped to lower 48 states from SE MN.

Came off a 73 727/318 combo, nice shape just needs to be cleaned up. $50 shipped to lower 48 states from SE MN.

I have 2 valve bodies for sale, one came out of a 1970 904 trans, the other from a 1973 727 trans, this one has a shift kit of some kind in it. Both pulled out for manual valve bodies. $40 shipped in the lower 48 for the pair.

I have a used 741 case with a 294 ring and pinion, small yoke, has caps, ring gear bolts also. The sure grip was taken out of it but will include an open center if buyer wants it. $175 shipped in lower 48 states from Spring Valley, MN, 55975.

Took this out of my 68 340 GTS with 727 trans. Was used until I switched to an aftermarket shifter. $125 shipped from 55975 to lower 48 states.

Came off my 68 dart gts with 340, was used until I put a manual valve body in. I have the bell crank also, need to get if off the intake. $175 shipped to lower 48. shipping from 55975, southern MN.

I pulled this out of a 71 904 to install manual valve body few years ago, been sitting since. $35 plus shipping from 55975, should fit in a large flat rate box.

Brand new in the box, high vibration blaster2 coil, new they are around $60, this one $45 shipped in lower 48 states from 55975.

I have 9 u joints still in boxes, bought at an auction few years ago and never used them. I searched some of the part numbers, some ram 3500 and some jeep. $75 shipped in lower 48 states from 55975.

Used Mopar Performance MSD Box with 7k chip. new blaster coil, Box was bench tested, works good. Coil is new never used. $165 plus shipping from 55975.

SOLD Carb 9103 S, was taken apart and checked, all parts look to be there, linkage is free. Carb came on a motor I bought, never tried using it. All linkage is off as well as top just sitting on base. Good for rebuild or parts. $45 shipped to lower 48 from 55975. SOLD

Small block 10.5 inch flywheel, neutral balance, came off a 71 340, will most likely need a resurface done, $65 plus shipping from 55975.

Took this out of a A833 aluminum od trans with 10.5 inch clutch, $30 plus the ride from 55975. Doesn't include Z bar in pic.

Set of 4.56 gears, less than 500 miles on new set of Richmond gears, 30 spline, 742 case large yoke, nice and quiet, $550 plus shipping from 55975. shipping is usually $60-$75 depending on location. pics taken just before install

Comes with bolt, cast iron $75 plus shipping from 55975.

Got this set in a parts car, cone sure grip pin is not broken or egged out in case, turns freely, gear look good, $300 plus shipping or buyer picks up from Spring Valley MN 55975

Got this trans in a parts car, goes into gear and turn freely, was full of fluid when I pulled it out. The tail shaft is cast iron and the longer one with 2 shifter mounts, 23 spline, Located in Spring Valley MN 55975, $250 buyer pays shipping or picks up.

Good shape, could use a repaint, $125 plus shipping from SE MN, 55975

Used clutch fork, came out of a 70 340 duster. $45 shipped to lower 48. Located in SE MN.

I have a 4 blade fixed fan with spacer for small block mopar, located in SE Minnesota, 55975, $25 plus shipping

Used Mopar solid cam and lifters, Mopar Part number p4529969, .509 lift, 280 duration, 238 @ .50. Ran it in my 340 dart, nice lope, and pulled to 6500 rpm. Ran best of 12.98 @ 105 in 1/4 mile, installed 4 degrees advanced. Needs adjustable rockers. After lash its under .500 lift. Lobes...

Set of factory stamped rockers and pushrods, took off a running 73 340 for a set of adjustable rockers, located in SE Minnesota 55975, $60 shipped.

A body front sway bar, mounts in pic not included, came off 68 dart gts. $55 plus shipping from 55975.

Set of stock rockers and shafts with pushrods I took off my 73 340. $30 plus shipping from SE MN 55975

I have a front sway bar off a 68 dart, has mounting hardware but no links. $100 plus shipping from SE MN 55975.

489 case, small yoke, 30 spline mini spool, 486 Richmond gears, I bought these used and ran it once at the track, $350 plus shipping from SE MN, 55975

Set of Richmond 4.86 gears with mini spool in a 489 case with small yoke. I bought these used and are little too low for what I need. $350 plus shipping from 55975. Will get pics up later.

Used set of gears I took out of a car I bought, has small yoke. Put about 500 miles on them, burns both rear tires, there is some pitting on some of the ring gear teeth and will need a seal. Turns freely, $350 plus shipping from SE Minnesota.