Search results for query: *

OK I am needing a pair of matching tunnel ram carbs! Holley 450 mechanical secondaries or vacum secondaries! Anybody got a pair laying around they are not using and want to sell! I would even look at a pair of 600 or 650 maybe.Needing rebuilt is OK just want complete carbs with no parts...

I need a good useable set of 340 pistons for a .040 overbore! Prefer with a dome but will consider any! 1967 - 69 Dodge Dart steel Hood (CLOSE TO HOUSTON FOR SHIPPING REASONS) Dodge Dart Front Bench seat for 2 door car(CLOSE TO HOUSTON) Rear engine plate for a smallblock

OK here I go again! I need the following items so I can get my project completed! small block fenderwell headers for a 67 - 69 dart dual quad intake for a 340 (prefer low profile but I ain't picky at this point trying to make my own crossram setup!) Bench seat located not far from...

Need a set of ceramic coated TTI headers for a 69 Dart with a 340 Four speed with Milodon oil pan ! USED IF IN REAL GOOD CONDITION OR NEW! Also need a LOW RISE Dual Quad intake manifold for a 340!

Still looking for a ste of 67-69 smallblock fenderwell headers,needin some repairs is OK! Also need a set of 340 pistons .040 over in size prefer 12.0 compression but will consider smaller or maybe 13.0 depends on what POPS UP! LOL If you got em e mail me,If not I have to order a new set and I...

I need a set of 340 forged pistons .040 over,also need a good "FORGED" 340 crankshaft,a set of A body fenderwell headers even if they need some repairs is not a problem or maybe even a KIT or set of weld up headers.I have seen a couple of these but didn't pursue them.I need these items for a...

Anybody out there got a set of old fenderwell headers for a smallblock dart! Somebody must have an old set laying around somewhere! I don't care if they need a little repair ! I NEED A SET BAD FOR MY 67 DART GASSER PROJECT! PLEASE if you have some you are not going to use I will buy them! May...

I need a set of smallblock fenderwell headers for a 67 Dart Gasser Project!Anthing out there! I don't expect new or perfect! Good useable is fine! Thanks Bobby

I need a nice A body roller.NO RUST or very minimum!I want to build a little A body for my Grandson.I have a nice stock 340 and 727 to install.Only looking for NICE and within 250 miles from Houston Texas! E mail me pictures and prices of what you have please! Thanks Bobby Dodson...

I am needing a set of forged .040 pistons for a 340 mopar.Anything from 10.5 to 1 compression to 12.5 to 1 compression.Let me know what you have and shipping to 77365 Texas! So if you have a set laying around and don't need them then turn them into CASH! Also lookin for the following 340...

I need a stationary crossmember for a 67-69 A Body.This is the piece that the removable cross member bolts to.My 67 Dart Gasser project has one but it has some rust in it so I would rather replace than repair.Also need rear floor pans.Mine have some rust in the lower recessed piece. Thanks...

NEED a set of 340 Fenderwell headers for a 67 Dart,used is fine I am building an OLD GASSER car and need a set. Thanks Bobby