Search results for query: *

Parting ways with my Slant. Motor is not assembled but have tons of parts accumulated. 1970 Block overbored 0.060" and o-ringed 1970 head cleaned and mag tested 1970 Crank mag tested and machined 0.010" under New Billet 90ksi main caps line honed with block New cam bearings pressed into block...

Hello gents, For sale, I have my entire, unassembled slant six build. It is incomplete as I was interrupted then started a new project. I'm not looking forward to selling, but I could use the funds. It contains the following: -1970 Block. Aftermarket mains. Line bored. 0.060" Overbore...

Fresh rebuilt A-Body Small Bolt Pattern 8-3/4 posi for sale. Tanked and restored housing and backing plates. Nice axels. RH studs. Low mile B-body 742 case 3.55 posi. New Green bearings. All new brake hardware, cylinders, and pads. Fresh turned drums with good meat on them. New pinion seal. New...

Freshly rebuilt disc brake setup and fresh bushing control arms for early a-body (63-72) small bolt pattern. Hasn't even been driven. Rebuilt factory calipers and freshly turned rotors. Moog bushings. Decided to switch to later model setup with bigger bolt pattern to match my new Dana 60...

Have a couple sets of '70 rods and Pistons out of two 225's. All of the rods are good condition. The pistons on one set is good, where the other set is cracked on every piston out of my boosted slant. I'll take the best offer on these. I don't need them. The crank is very clean, almost no wear...

I have a completely redone a body posi 3.23 rear end with totally brand new brakes, brake lines, turned drums, tanked and painted housing, and new bearings. It is currently underneath my Dart, but it has never been driven. I want to switch to a Dana or even stronger rear end for mt build...

Freshly tanked and machined (.030" overbore) 318 block and freshly machined forged steel crankshaft (.010" under") with new forged steel H-beam rods, new complete bearing kit, and freshly 3-angle valve jobbed 360 J heads. Started a Twin Turbo 318 setup, but decided to go back to the turbo /6...

I've got a '68 318 block tanked and machined .03" over, a '68 forged steel crank machined .01" under, entire bearing kit and high performance forged rods. Along with it are a pair of 360 J heads that are reseated and have a 3-angle valve job. All freshly done. I've got over $2,000 into the...

Early A-body small bolt pattern. Not sure what gear ratio(possibly 4.10). The rear end is missing the brass v-block for the brake lines and the internal drum hardware, but I have the drums. No leaks. Had 90,000 miles on it when I replaced it with a posi 8-3/4. Would make a good roller rear end...