Search results for query: *

The cap is an MSD for their billet dist. What type of drill bit would I need to drill the cap? I have bits for metal but I don't know if these would work. Fred B

How do you change the bulb on the dash light reverse indicator under the dash? Fred B

I went to start my car and the battery was low and wouldn't turn the engine over. Battery was checked and is good. Somebody told me that there is probably a short draining the battery. They told me to take 1 cable off the battery and hook the test light clip to the cable and the point of the...

Ok here we go again. If I check the voltage at the fuse box I get 10.3 with ignition key on accessory. With off I get 12.4. With the engine running I get 14.2. What could be causing this? Fred B

Well since I got the ignition fixed now I have something else. When I put the headlights on my radio shuts off then comes back on. What would cause this? Also sometimes the lights pulse but not all the time. I think maybe it's time for new wire harness. Fred B

Well I finally found out why my car wasn't starting. I checked the ignition 2 wire and there was power to it. I thought WTH. But when I put a volt meter on it and cranked it over the volts dropped to 7. MSD told me to put a toggle switch on. I really don't want a toggle switch. What would cause...

Well I thought I had my no spark problem fixed. Found loose wire and fixed that. Started no problem. That was toward the end of summer. Well now same problem. No spark at plugs. My MSD ignition tests good. I pulled the coil wire and placed it close to metal surface. When I turn the key it turns...

On my Scamp, when I go to start the car with my key, it won't start. There is no spark. But....if I put the key on, and use a jumper wire to start it with the solenoid on the fender well, it fires right up. And if I shut it off with the key, it will start right back up with the key several...

How much higher do you set the limiter from when you shift? Like if you shift at 6500. Would you set it 300 to 500 above that? It's a 4 sp if that matters. Thanks for any info. Fred B

What should the voltage output be at the battery if everything is working correctly? When I rev the engine I get 13.5. Should it be higher? Thanks for all replies. Fred B