Search results for query: *

Ok I'm having starting issues. I only have 8.5 volts at the coil. Not enough to start the car. If I run a jumper from a good 12 volt source to the coil car starts with no problem. Details include the following; MSD coil, MSD ready to run distributor. No MSD box. Any ideas on where to start?

I'm a little confused when it comes to wiring diagrams. Looking the diagram in my service manual, I see ignition 1 and ignition 2. Am I wrong in assuming they (1 and 2) are for Start and Run. If so, which is which?

Can I use this crank on a 3 speed wiper motor? If not, where can I get a 3 speed arm?

Ok guys and gals let see your creativity when it comes to junction/relay boxes. I've seen people run the + cable to the engine compartment into a junction box and run relay from there. Lets see some pics. Thanks.

I'm converting to a 3spd wiper motor on my 6 pack Dart. Looking for advise as the 2spd and 3 spd are wired differently.

I'm going to replace the harness's in my 68 Dart. I'm not an expert with electrical so I need recommendations on easiest install of new wiring harnesses. Thanks in advance. Details.. 1968 Dart 500ci stroker, MSD 6AL, MSD Billet Distributor, Electric cooling fans, Trunk mounted battery.

I want to relocate the battery to the trunk. Is there a kit that comes highly recommended?