[SOLD] 1967 Barracuda Commando Stock Y-Pipe and intermediate pipe

[MidnightSwinger]

This is the stock exhaust system from my 273, I am selling the y-pipe and as much of the intermediate pipe as the buyer would like/willing to pay to ship.

The muffler is not stock and was replaced by Midas in the 80’s, so I am not sure if the tailpipe is factory or not. You can have it if you want it and you are local. Too big and bulky to ship the whole exhaust IMO.

Like previously stated, I’ll cut it down to whatever size you want, and I can take more pictures.

$100 plus shipping from 95695 Woodland CA.

 

[65 Dartman]

Other than no resonator it looks virtually the same as a Commando/Charger 273 exhaust. The intermediate pipe should be about 2.25 or maybe 2.5 ID

 

[MidnightSwinger]

Other than no resonator it looks virtually the same as a Commando/Charger 273 exhaust. The intermediate pipe should be about 2.25 or maybe 2.5 ID

Thank you for that, the intermediate pipe is definitely 2 1/4 may be closer to 2 1/2 inch, but it’s compressed, so it’s hard to really tell.

 

[66fs]

They were 2.5 at the Y pipe originally

 

[65 Dartman]

Ulf @65dartcharger is always looking for early A and 65 Dart stuff. He might be interested in the Y Pipe as well as the headpipe.

 

[MidnightSwinger]

They were 2.5 at the Y pipe originally

First pic is next to some 2 1/2 inch mandrel bent tubing. Looks really close to me second picture shows the compression I was talking about.

 

[66fs]

First pic is next to some 2 1/2 inch mandrel bent tubing. Looks really close to me second picture shows the compression I was talking about.

View attachment 1716252271

View attachment 1716252273

They used to put flats where they needed to for clearance.

 

[65dartcharger]

Ulf @65dartcharger is always looking for early A and 65 Dart stuff. He might be interested in the Y Pipe as well as the headpipe.

Thanks Don for having me in mind. However that Y-pipe doesn't fit against the 64/65 exhaust manifold on the drivers side.