[FOR SALE] 1968 340 motor with edelbrock aluminum heads and intake

[rdoylejr]

1968 Chrysler 340. complete motor less carb and distributor. Ran great when I took it out of the car. I replaced it with a date correct motor. The block date code is 6-22-1967. I am asking $2200 or best offer. Local pick up only in Cape Coral Florida. The heads are Edelbrock performer rpm #6077. There is no vin # on the motor.

 

[gtsdude]

Any chance there is VIN # on the bell housing rail behind driver side head?

 

[rdoylejr]

I did not see one. I updated the ad with photos

 

[gkmopar]

Any chance there is VIN # on the bell housing rail behind driver side head?

Could you take a picture of the top flange area of the block behind the driver side head?

 

[340doc]

Do you have any more info on it? Cam? Stock bore? Etc, thanks.

 

[rdoylejr]

No . I have had the car it was in for 12 years. It is a show car that has been trailered to car shows and concourses since I have owned it. I have put less than 1000 miles on it in 12 years. There is nothing wrong with the motor , I just wanted a date correct motor in the car. You can message me.

 

[340 demon 72]

Will you sell heads separately?

 

[rdoylejr]

No I want to sell the motor with the heads. Thank you. Bob

 

[cuda620]

Do you know at least the cam specs and compression and over Bore? Thanks.

 

[rdoylejr]

No I don't know about the cam or compression. I bought the car with the motor in it. I have never had the motor apart.