Bills70
Well-Known Member
can anyone tell me where the ground wire on the parking lamp's of my 1970 Duster attaches too vehicle, I did not take this car apart and it is my first Mopar ever! a picture would be great!
1970 Duster Parking Lamp
- Thread starter Bills70
- Start date
-
70Duster440
Well-Known Member
There's a short wire from the spade terminal on each parking lamp to a sheet metal ground screw on the core support closer to the radiator on each side. Look for a screw or a hole for a screw on the core support nearby. You'll see a bolt rather than screw in my photo only because of mods and several ground wires attached at that point.
Bills70
Well-Known Member
Thank you very much! is that a 1/4-20 bolt? I can see know that I am going to be asking a lot of questions.
70Duster440
Well-Known Member
Could be - don't recall what I used. Yours should just be a short sheet metal screw that goes in pointing towards the grille. Check the hole and put the appropriate size screw in (no nuts or bolts).
Something like one of these:
Something like one of these:
Bills70
Well-Known Member
that will work! needed to know what size new terminal I needed to put on wire! thanks again! I got my grill on today, headlights and bezel also. one thing at a time. I did a little research today and I am thinking about putting a QA1 K member in my car to replace 6cyl K member. I just hope there is nothing else that goes behind grill, hate to have to pull it back off! there are two 5/16 holes on both side's of car that looks like where the ground wire would have been connected.
-
