dustya_383
Well-Known Member
Hey guys unfortunately I have to sell my 1st car my 74 duster
Was my autocross project but now need to sell for financial and space reasons.
I currently do not have a drivetrain for this car . It's sitting in my garage on giant body casters torn
Needs some body work . I was planning on putting new qtrs on it and doing a full tub. Did not purchase those yet but may if I cannot sell the car .I WILL NOT SEND THIS CAR TO THE JUNK YARD . So I much rather have someone take over. I have fenders hood doors grill kframe windows still In place and gas tank .I have All interior pieces except front bench seat . All panels wrapped in black vinyl with nice pattern including dash pad. And rear speaker deck area . Have trim .. 1 piece is bent
RUST AREAS
Drivers side door hinge area has rust . Have access to patch panel if interested .
Trunk floor is rusted was going to cut out for cell anyways.
Drivers side A pillar where vinyl top was .. Cancer already cut out just need to put patch piece . Floor boards have surface rust but most part are very solid.
Mini tub had already been started
Has trans tunnel cut out . I had a 4speed in it a couple years ago when I first built my engine .
Asking $800 for the car
It's on non op but is insured .
I have Badarts front upper arms and lower arms. With upper mount adapters for extra
$1300 for car w badarts parts or $800 without them
I am located in San Jose ca this is a perfect car for drag project
I will get more detailed pics asap
Was my autocross project but now need to sell for financial and space reasons.
I currently do not have a drivetrain for this car . It's sitting in my garage on giant body casters torn
Needs some body work . I was planning on putting new qtrs on it and doing a full tub. Did not purchase those yet but may if I cannot sell the car .I WILL NOT SEND THIS CAR TO THE JUNK YARD . So I much rather have someone take over. I have fenders hood doors grill kframe windows still In place and gas tank .I have All interior pieces except front bench seat . All panels wrapped in black vinyl with nice pattern including dash pad. And rear speaker deck area . Have trim .. 1 piece is bent
RUST AREAS
Drivers side door hinge area has rust . Have access to patch panel if interested .
Trunk floor is rusted was going to cut out for cell anyways.
Drivers side A pillar where vinyl top was .. Cancer already cut out just need to put patch piece . Floor boards have surface rust but most part are very solid.
Mini tub had already been started
Has trans tunnel cut out . I had a 4speed in it a couple years ago when I first built my engine .
Asking $800 for the car
It's on non op but is insured .
I have Badarts front upper arms and lower arms. With upper mount adapters for extra
$1300 for car w badarts parts or $800 without them
I am located in San Jose ca this is a perfect car for drag project
I will get more detailed pics asap
