[SOLD] 273 flywheel bolts

-
Status
Not open for further replies.
J

jamesoverlie

Member
Joined
Jun 12, 2009
Messages
8
Reaction score
0
Location
Orlando Fl.
Rating - 100%
1   0   0
Contact seller
I am converting my 1965 273 to the truck slant six 10 inch clutch and since the original 9 1/2 only used three flywheel bolts I need three more now. These are the ones turned by a 1/2 wrench.
Orlando Florida
 
Yes, the ones to volt the pressure plate to flywheel. They are 7/8th inch (below the head) My 273 Cuda originally came with the 9 1/2 inch clutch and only used three bolt pressure plate. The ten inch clutch was used on the slant six trucks and is a easy upgrade. I did not want to use a hardware store bolt as they are all now made in China so if I can get some original Mopar bolts that is what I want.
 
I don't have the bolts, but I do have a 4 speed setup out of a 65 dart if you are interested.
9" flywheel, bell, 833, you would need a shifter, and hump.

and I am in Orlando.
 
Thanks for the reply but my car is a four speed from the factory, I have it apart now and bought a 10 inch slant six speced out for a truck. Thats only 1/2 inch less than a 340 without having to change the bell housing.
 
I just put a 10.5" behind my 340 in my 64 dart. along with a iron 833od.

Brewers was very helpful in getting me the needed parts.
 
Status
Not open for further replies.
-

Back
Top