moparcas
moparcas
What crank do i need to make a stroker 318. I am not sure on the bearing size but i think its same as 340.:read2:
318 stroker
- Thread starter moparcas
- Start date
-
EL5DEMON340
Well-Known Member
you would use the same one listed for the 340/416, your displacement would be about 390. you could also use the 4.125 crank from K1 that would take the 340 to about 427" or make your 318 about 401 .
the easiest route is 4 crank...uses same diameter bearing as the 318/340 engines do.
whoever you buy the crank from...buy the bearing also...depending on wheather is is a forged or cast crank the rod bearing will need fit the radius of the rod journals./
KB makes a forged piston flat top or dish......scat I beam 4340 rods do not need any grinding.
whoever you buy the crank from...buy the bearing also...depending on wheather is is a forged or cast crank the rod bearing will need fit the radius of the rod journals./
KB makes a forged piston flat top or dish......scat I beam 4340 rods do not need any grinding.
-
