340 Emblem install help needed

[BigWaveDave]

I'm installing the twin scoop 340 emblems on my 1970 Duster.
Not the Snorkel but the ones that came on Darts and Demons too...
There are no existing holes on them. was wondering if anyone can help with the proper location of the emblems?
Was hoping for some measurements that were accurate from factory.
I'd really appreciate it if someone can give me a hand ,,
THANKS!!
:thumblef:

 

[homecloned]

Mine are 1" in from the front edge and 1" up from the bottom. Measure distsnce between pins. Mine are @ 1 1/2" apart.

 

[BigWaveDave]

Great thanks,
Did u happen have the measurement from the bottom of the back side of the emblem?
I've noticed that it actually tapers from high in the front to low in the back due to the
hood angle...

Thanks again!

 

[OneOfMany]

Here's measurements on an orginal setup.

 

[BigWaveDave]

Fantastic,,
Thank you both for your help!!