k7nqkb
Member
Hello - need some advice - please
Building a 340/418 stroker motor. I currently own the block, Eagle forged crank, H-beam forged rods, Diamond dished pistons and Brodix B1BA heads.
I'm thinking of a M1 single plain intake and a Holley 870 Avenger carb?
I need advice on which cam and lifters everyone thinks would be best.
Its going into a 1966 Dodge Dart GT - A500 Transmission (yes its been built) 3.55 posi rear end. The car will not be drag raced - just a nice cruiser! AND - I want it to run on pump gas.
Thank in advance!!
Building a 340/418 stroker motor. I currently own the block, Eagle forged crank, H-beam forged rods, Diamond dished pistons and Brodix B1BA heads.
I'm thinking of a M1 single plain intake and a Holley 870 Avenger carb?
I need advice on which cam and lifters everyone thinks would be best.
Its going into a 1966 Dodge Dart GT - A500 Transmission (yes its been built) 3.55 posi rear end. The car will not be drag raced - just a nice cruiser! AND - I want it to run on pump gas.
Thank in advance!!
