Mgc340
Well-Known Member
Mopar R3 Siemese bore block
Short deck
4.125 bore
3.35 Bryant crank
Carrillo rods
Bill Miller pistons
Dry sump with Peterson pump
W9 heads- hand ported
Mopar 598 intake
Jesel rockers
Jesel keyway lifters
W8 Moroso valve covers with spacer plates for the w9 heads
I have most of the oil plumbing etc
This motor was last freshened by Stanton engines. Break in time only, this was a spare motor. This is a low compression deal around 9.5:1.
It’s been fully taken apart. If it were mine I’d buy a set of new piston rings, head gaskets etc and put it back together. The bearings look awesome.
I can ship via Fastenal hardware for $150-200 through out the lower 48.
$8,500
Short deck
4.125 bore
3.35 Bryant crank
Carrillo rods
Bill Miller pistons
Dry sump with Peterson pump
W9 heads- hand ported
Mopar 598 intake
Jesel rockers
Jesel keyway lifters
W8 Moroso valve covers with spacer plates for the w9 heads
I have most of the oil plumbing etc
This motor was last freshened by Stanton engines. Break in time only, this was a spare motor. This is a low compression deal around 9.5:1.
It’s been fully taken apart. If it were mine I’d buy a set of new piston rings, head gaskets etc and put it back together. The bearings look awesome.
I can ship via Fastenal hardware for $150-200 through out the lower 48.
$8,500
