360 help with edelbrock

[gotdust57@yahoo]

i am in the middle of putting a 360 with edelbrock intake in my duster, and am stumped. the edelbrock has so many holes for hookups i am not sure which ones to use,or which ones to plug, temp gauge oil sending unit and so on, anybody,got any pic that would help me out? thanks

 

[AdamR]

oil sending unit is in the block next to the distributor so you only need one hole for the water temp. Int needs to be in a water port. Should be one from/right next to the heater hose nipple.

 

[gotdust57@yahoo]

so can all others be plugged off, is there anything else besides oil and water gauge that needs something? really thankful for help

 

[Johnny Dart]

Here is a pic of a EDE Performer.
Everthing is plugged except the heater hose and by-pass hose.

Hope this helps.

 

[71valiant]

Nice Intake.

 

[DragginMAster]

i plugged everything in mine e like the above photo with the exception of a water temp sensor.

 

[gotdust57@yahoo]

where does water temp sensor go? thanks all

 

[GoodysGotaCuda]

Temp sender will go near the thermostat housing, there should be a couple tapped holes there for it.

 

[gotdust57@yahoo]

the motor temp sensor must be the smaller tapped hole left of water temp sensor and heater hose by pass right? thanks

 

[GoodysGotaCuda]

that should be the only hole where the stock style temp sender screws into. look at the picture above, at the passenger side of the intake, between the first and second bolts on the intake manifold you will see the temp sender..

 

[gotdust57@yahoo]

thanks guys for all your help should be on right track now