68dodge
Well-Known Member
440 stroked to a 505, 625HP, 653 FT. torque, stroker kit is from 440 source, H-beam rods, platinum series pistons, chevy size H series rod bearings,12.4 compression, V-series main bearings, 1/4" main girdle setup, Harland Sharp 1.5 roller rockers 1.5, SFI fluid damper, high torque mini starter, SFI approved flax plate, Hughes 4000 stall convertor, Heads are Edelbrock RPM 75cc fully ported with race valve by Hughe engines, Comp cam roller XR292HR-10 .549-.544, Victor intake that was gasket matched to heads, Quick fuel 1050 AN carb, MSD Distributor, Meziere electric water pump. No Headers with motor.
727 transmission also with motor, Built by CRT, has a Hughes 4000 stall convertor. Motor and trans. only have 6 runs down the track. Can still hear it run and drive. In Pa. $12000 OBO
727 transmission also with motor, Built by CRT, has a Hughes 4000 stall convertor. Motor and trans. only have 6 runs down the track. Can still hear it run and drive. In Pa. $12000 OBO
