[SOLD] 70 dart rear end and brakes oregon

-
Status
Not open for further replies.
Anyone out there in oregon have parts? Heck I would even take a wide 8 3/4 rear end to narrow down if it was complete? I need big bolt pattern
 
they are 5x4.5", they do have a 2+" offset on center section but a lot of people run 2 short side axles and just cut 2 1/2" off long tube. There is a sticky on it. If you still want an 8 3/4" I have one from a truck that is complete but would have to be narrowed. pm if still interested.
 
There are different 8.8 rears. Mustang 8.8 are different than Explorer. What is yours out of? Most folks here in the Portland Area want big bucks for an a body 8-3/4.

Have you tried Wild Cat Wrecking in Sandy Or? They are all Mopar and may have one or a 66-67 B-Body one. A 73-up 8.25 might be an option too?

What kind of use and power level are you looking at running?
 
Well I'm wanting to run about 15psi with a turbo slant I'm running an hx35 turbo custom header probably a 650 mighty demon carb hopefully mid 300hp would be awesome to the rear wheels
 
Status
Not open for further replies.
-

Back
Top