73+ BBP Complete Disk Brake set-up

-
Status
Not open for further replies.
damraider

damraider

FABO Gold Member
FABO Gold Member
Joined
Aug 29, 2007
Messages
1,293
Reaction score
236
Location
San Ramon , Ca
Rating - 100%
16   0   0
Contact seller
Hello, I have the complete set-up I had done for the Barracuda I sold . New rotors, bearings , calipers, pads , 73 up spindles with brand new lower ball joints . Upper A-arms with brand new off set Moog bushings installed , and new upper ball joints installed . New 15/16" master cylinder for manual brakes. New brake lines also. Ready to bolt in and I'm in Hayward , Ca 94545 . $500.00 . I will ship at buyers expense , could probably get it in four or five Flat rate boxes .

Thanks,

Steve
 
[Man your price is way out of line I will pay u$ 125 shipped /QUOTE]

Really ? I offered to break up the set and sell the arms to you for $200.00 shipped .
The new ball joints were $85.00 , the new offset bushings were $40.00 , I have two and a half hours installing them ( I like to get $20.00 an hour) so that is another $50.00. The arms are probably worth $50.00 bare .I had figured $18.00 to ship .

I think $200.00 was a fair deal but good luck on your search .

Thanks,

Steve
Click to expand...
 
PM sent on the A-arms and master cylinder.... BTW is 15/16" the stock MC size, if not how does it compare performance-wise to stock? My '70 Duster came factory with K-H front discs and I'm upgrading to the '73-up ones.
 
Guess you are right I wasn't figuring all the exspence n labor charge ( not ) just kidding
damraider said:
[Man your price is way out of line I will pay u$ 125 shipped /QUOTE]

Really ? I offered to break up the set and sell the arms to you for $200.00 shipped .
The new ball joints were $85.00 , the new offset bushings were $40.00 , I have two and a half hours installing them ( I like to get $20.00 an hour) so that is another $50.00. The arms are probably worth $50.00 bare .I had figured $18.00 to ship .

I think $200.00 was a fair deal but good luck on your search .

Thanks,

Steve
Click to expand...
Click to expand...
 
dang, that's a good price. I was looking to do everything like that to my same disc assembly, and your was cheaper and all the work done. Somebody is gonna get a sweet deal on that setup.
 
Status
Not open for further replies.
-

Back
Top