A-883

[ozcuda70]

Hello i have a small problem with oil leaking out of the reverse detent mechanism nut . does the ball bearing and the spring cause mutch of a problem when reinstalling into the box . does eney one have eny suggestions or tricks to help me out .
thank you

 

[TheDeputy]

The detent spring/ball assembly has two hex parts, if you loosen the outer hex plug you can take out the spring and ball with a magnetic pen or something.
Then you can take out the other piece of the assembly and put on a new gasket.
Slide the ball and spring in place, put a new gasket on the outer plug and screw it in. Finished.

Oh, and don't forget to drain the trans of it's oil

Antoon

 

[ozcuda70]

Thanks for the advice i am going to give it a go on the weekend wish me luck

 

[valle6062]

Thanks for the advice i am going to give it a go on the weekend wish me luck

I have the same problem with my A833, it was the seal-rubber-ring that have to be changed. And that was a big operation. To do this I have to demontage the whole transmission, be carefull, there is a lot sof small bals in there.:thumblef::thumblef: