bolt head id on 1969 body

[afazio01]

guys looking for a little help on following bolt id and where they go;

1. the vibration damener to pulley, are the the 'E' head bolts?

2. the engine ground to block are they the "I/C/S" bolts??

3. Is there a washer on the bolts that connect the pulley to water pump?

4. what is on the head of distributor clamp bolt?

any help appreciated

 

[fishy68]

1 and 2 I have no clue on. What do you mean by "E" and "I/C/S" bolts???

3. Yes. 3/8" lock wacher in some places. 3/8" flat washer in other places.

4. ??? What do you mean "what is on the head"?

Are these question are do to you doing a concours restoration?

 

[afazio01]

1 and 2 I have no clue on. What do you mean by "E" and "I/C/S" bolts???

3. Yes. 3/8" lock wacher in some places. 3/8" flat washer in other places.

4. ??? What do you mean "what is on the head"?

Are these question are do to you doing a concours restoration?

Hi,
yes, councours. these are makings on some of the bolt heads and I am just finishing a restoration on a 340 dart. I figured I might as well get the right bolts oin the right place

thanks

 

[fishy68]

Hi,
yes, councours. these are makings on some of the bolt heads and I am just finishing a restoration on a 340 dart. I figured I might as well get the right bolts oin the right place

thanks

Ok. That explains why I didn't know what you were talking about. Sorry I'm not much with concours resto's. If you don't get an answer here you might try www.bigblockdart.com

 

[George R]

1 -- yes
2 -- i don't remember
3 -- yes
4 -- bolt head is H (it's an oddly shaped H)

George