Hey guys I was looking threw the old craigs list and found this ad http://stlouis.craigslist.org/pts/4011751646.html and I was thinking about getting them for my 72 duster. But does anyone know what car these came out of by chance? And if they will just bolt up to my car that has a bench seat or will I need to drill more holes? Thanks!
Bucket Seats
- Thread starter bbizelli
- Start date
-
73SwingerBuild
Well-Known Member
You will need to drill holes and add reinforcement plates to the inner seat mounts (near the transmission tunnel) on both sides. That is assuming they are indeed Mopar seat (I'm not sure myself).
74DartSwinger360
The Brat Pack
They are not Mopar at all cause of the lever to adjust seat front to back is in front of the seat.
Mopar adjustments were always on the sides.
They are 85-92 Chevy S10 and Camaro seats. They are the exact seats that were in my 88 s10 Blazer except mine were tan.
Another tell they are chevy is the adjustment lever for tilting the top of the seat back.
Also 60s and 70s and most 80s Mopar seats the seat back only folded forward for entrance to the back seat and did not recline rearward at all.
These are definitively NOT Mopar seats
Mopar adjustments were always on the sides.
They are 85-92 Chevy S10 and Camaro seats. They are the exact seats that were in my 88 s10 Blazer except mine were tan.
Another tell they are chevy is the adjustment lever for tilting the top of the seat back.
Also 60s and 70s and most 80s Mopar seats the seat back only folded forward for entrance to the back seat and did not recline rearward at all.
These are definitively NOT Mopar seats
-
