Can someone please tell me the bolt pattern for my wheels? I don't have the tool to measure them; nor do I have a manual. My car is a '74 Duster. The wheels are 14". (I have no idea why the previous owner had the washers on there)
Can someone tell me my bolt pattern?
- Thread starter Max_118
- Start date
-
Those should be 4 1/2" bolt pattern...
Single caliper disc...
Single caliper disc...
Looks like 5x4.5. Just measure it. Easy to do.
doug 371
Well-Known Member
4.5 maybe he was using them as a wheel spacer...
Ahoey
Well-Known Member
My 74 dart has 4.5 in stud circle very common on that era of mopar
This
Welcome to FABO!!
People like to play...sorta like hanging out in the garage and razzing each other.
That era was mostly 5 on 4.5". Certainly someone could have swapped in a different rear. Tolerances were a little loose back then and rears can be off by as much as three quarters of an inch. Like @doug 371 said, probably used washers as a spacer.
People like to play...sorta like hanging out in the garage and razzing each other.
That era was mostly 5 on 4.5". Certainly someone could have swapped in a different rear. Tolerances were a little loose back then and rears can be off by as much as three quarters of an inch. Like @doug 371 said, probably used washers as a spacer.
Ahoey
Well-Known Member
5 studs on a 4.5 inch diameter circle only so many places you can put 5 studs evenly on a 4.5 inch circle pay attention to centre hole for axle those very a lot. Have fun and the razz like water off a ducks back LOL.
-
