early 70s engine mounts for 340/360

[Airborne_Tanker]

I need some engine mounts bracket that go to the block they dont need to look good just be functional and not super expensive. They are for a 70-72 k member if they cost to much i have a few things i can trade. Like truck mounts, some edlebrock valve covers (the cheapo ones has some rust on em to), big block 400 oil pump, and thats about it.

 

[Bulldozer]

http://www.forabodiesonly.com/mopar/showthread.php?t=185177

im pretty sure these will work for a 360. you may have to shim the drivers side boss. perhaps someone that knows for sure will chime in.

 

[Airborne_Tanker]

Those are the ones I found in, the floor board earlier and they wont fit right

 

[Bulldozer]

i see ....some will pop up for you or you can buy them new as well...

 

[Airborne_Tanker]

where can i get new ones from i havnt seen any

 

[crackedback]

new ones, maybe shumaker creative services.

I may have a set from a 340 swinger. I normally sell them for $100 shipped for the pair, drivers/pass side.

 

[Airborne_Tanker]

actually i can use these i belive pm sent